Steven's House monitor

PondMode is
Alarms:-

0 Then Print "Tap at Minimum" else print "" ?> 0 Then Print "Tap at Maximum" else print "" ?>
0 Then Print "CRC fail on temp sensors" else print "" ?>
0 Then Print "No reply from temp snsors" else print "" ?>
0 Then Print "Main Pump Fail" else print "" ?> 0 Then Print "Main Pump always on" else print "" ?> 0 Then Print "Sump Pump always on" else print "" ?> 0 Then Print "No AC Power" else print "" ?>
0 Then Print "Pond level switch short circuit" else print "" ?> 0 Then Print "Pond sw D fail" else print "" ?>
0 Then Print "Pond sw C fail" else print "" ?>
0 Then Print "Pond sw B fail" else print "" ?>
0 Then Print "Pond sw A fail" else print "" ?>
0 Then Print "Pond level beyond limit too long" else print "" ?>

Tap Position =
TapTarget =
Average Tap Position = >7) ?>
Av steps per hour = >4) ?>
Slow speed (steps per min) =
^{tap settle time :}
Slow Speed =
Tap Boost =
Pond Switch:

Heater Mode is help

UpperTemp = >2) If ((UpperTemp4 MOD 4) > 1) Then print ".5" ?>
Lower Temp = >2) If ((LowerTemp4 MOD 4) > 1) Then print ".5" ?>
Outside Temp = >2) If ((OutsideTemp4 MOD 4) > 1) Then print ".5" ?>
Solar Temp = >2) If ((SolarTemp4 MOD 4) > 1) Then print ".5" ?>
Garage Temp = >2) If ((GarageTemp4 MOD 4) > 1) Then print ".5" ?>

Target Temp = >3) If ((TargetTemp8 MOD 8) > 3) Then Print ".5" ?>
Desired Temp = > 1) If (((DesiredTemp2) MOD 2) > 0) Then Print ".5" ?>

= $8) Then Print "Tank is FULL" else print ""?>

Pump Duty = >5) else print "" ?>%
Sump Duty = >5) ?>%

KWh used in hrs
Current usage = watt

Line Volatge is ripple mV